1:12 scale cushion tutorial (for pointy corners!)

I wanted to put together this quick little tutorial after Kitty said that she found getting the cushions pointy enough was the bane of her life, strong words, I felt like that once too Kitty...but then I worked out a new way of making cushions, inspired by Gill's patchwork tutorial. :D

I felt so bad about the thought of anyone else suffering with their unpointy enough cushions, I had to get this out there pronto! :D

You will need:-

• Fabric
• Needle
• Thread
• Paper (preferably graph)
• Glass beads or stuffing
• Iron/Hair straighteners

Carefully cut out a template using graph paper, keep it as square as possible, then cut a piece of fabric slightly larger.

Turn the fabric over and place your template in the centre.

Fold fabric (preferably along the grain) using the paper to guide you. Use your nail to press the edge down.

Press the fold, either using hair straighteners or an Iron, you will need to repeat this for each fold.
I use hair straighteners, because they're quite handy for mini ironing.

Make sure to test a scrap piece of your material, just in case it melts. 

Fold as before, but on the opposite side from the last fold, and press. 

Fold as shown, press, then fold the other side and press. Try your best to keep the sides of this particular fold, as square as possible, it helps to begin the fold at either end and move inwards towards the centre, using your fingers to press the fabric down.

Now make another one. I usually use plain fabric for the back, to conserve the printed fabric. An old pillow case is a great source of plain fabric.

Abracadabra.........the fabric will now change (apologies for the continuity error, we will now be demonstrating with a new fabric...)

Cut a length of fine thread, for this cushion I think I used about 35 cm. Tie a knot at one end, thread it, and insert the needle into the corner from the reverse of the fabric. 

You should sew from this point, where you can see the folds (this means you will have a less fussy edge to sew later on). Connect the two with your needle and thread as shown.

Now that the two pieces are joined, begin sewing your cushion together. I use the ladder stitch, putting the needle under just a thread or two of the fabric. Do not sew the inner folds together, work over them. 

Ladderstitch diagram.

When you are almost back at the beginning, you can start filling the cushion. I use micro glass beads, I can't remember which size, but I bought them from Mohair Bearmaking supplies. I  hold the cushion over a jar of them, and use a teaspoon to drop them in, until it's just right. You may have to smoosh the cushion a bit to fit them in as you go.

Now carefully holding the cushion, sew up the hole, still using the ladderstitch. 

Sorry for the blur, under the last stitch at the corner put the needle under and draw through until you are left with a small loop...

...then put the needle through this loop and draw through to create a knot close to the corner. Repeat once or twice more. 

Then push the needle down through the corner as shown (where you just made the knot)

Push the needle through the cushion until it pops out somewhere on the other side.

And cut the loose thread. If there is a little short bit poking out after you have cut the thread, smoosh the cushion and it should disappear.

The only downside about this method, is that the stitches will be slightly more visible than they would be if you used the "turning inside out" method, you can always glue a strand of thicker thread around the cushion to act as piping, which I haven't tried out yet, but I imagine it would work very nicely. 

Now back to my secret project, until Christmas...

Byeeee! :)